This is where nosotros left off concluding time. After removing the baseboards > Influenza A virus subtype H5N1 elementary base, made out of 2 x 6's was added to back upwards the cabinets.
This is a inexpensive solution in addition to welll, I similar that it's really strong! I used steal holes to screw it into the floor, of course, leveling it.
 |
| Kreg Rip-Cut | Ryobi Circular Saw |
For the Boxes I used a lower flat plywood, they're going to hold out covered on the outside, no demand to invest inward improve materials.
I ordinarily enquire the guys at the Home Depot to rip the large sheets inward 2 pieces for slow transport. I made all the smaller cuts at home. For those, I got this novel tool, the Kreg Rip-Cut, in addition to it made this task means easier.
No demand to mensurate every unmarried slice when they are the same size! It was a chip hard to brand precise cuts for the long boards, or when the blade of the saw was far away from the guide. But, overall, I actually liked it.
Needles to say, this task went really fast.
 |
| Right Angle Clamp | Spax Screws | Drill |
For attaching the move past times cleats I used to a greater extent than or less other novel to me tool: A correct angle clamp. - Life changing. I LOVE it!
I used Spax screws, which I also dear because in that place is no demand to exercise predrills. went inward similar butter! :)
My Ryobi Jig saw is my larn to for those outlet cutouts.
The boxes were secured together amongst screws driven to the forepart in addition to back. Then, they were secured to the wall in addition to to the base.
My side past times side footstep was to construct the human face upwards frames, precisely somehow I receive got no pics of it. The showtime human face upwards frame went on smoothly - cuts- steal holes - gum - screws. But, I had problem putting together the minute frame. :/ While screwing the pieces together, the woods kept on splitting each fourth dimension I drove a screw. GRRRR!
I had to larn cutting a novel slice of wood, opened upwards the holes in addition to drive novel screws. It happened similar 3 times! :( So, I stopped working in addition to resumed move the next day.
Ha, it pays to receive got a expert break. Both frames were done in addition to I began edifice the countertops.
I used 2 pieces of plywood that I glued in addition to added similar a hundred screws to brand certain they'll remain together for life! :D
 |
| Ryobi Cordless Brad Nailer | Gorilla Glue |
I made the error of cutting the plywood likewise short. In guild to solve this work I added to a greater extent than or less other 1 x 2 slice on the other long side.
And hither is how they were looking Dominicus evening...
When I began brainstorming decorative toe kicking ideas amongst paper. My married adult man said the correct side looked good. For me, it had to come upwards downwardly amongst a wider board in addition to lowering the design.
But hey, we'll move out that for side past times side time.
Check the next links for consummate details nearly this project:
First Part: The starting point
Second part: The Base Cabinets - You're here.
Third part: The decorative Toe-Kick
Fourth part: The Shelves
Fifth part: The Bench
For to a greater extent than Home DIY ideas cheque these out:
*This post contains affiliate links for your convenience*
No comments:
Post a Comment